README.txt
==========

Contents
--------

o NSH Project
o Loading and Executing Code
o Console Output
o STATUS

NSH Project
-----------

nsh.zfpproj is a simple ZDS II - ZNEO 5.0.1 project that will allow you
to use the ZDS-II debugger. Before using, copy the following files from
the toplevel directory:

nuttx.hex, nuttx.map, nuttx.lod

to this directory as:

nsh.hex, nsh.map, nsh.lod

Loading and Executing Code
--------------------------

1. Copy the files to this directory as described above
2. Connect the ZiLOG XTools USB debugger.
3. Install the USB driver from the ZDS-II device_drivers directory
4. Start ZDS-II and load the nsh.zfpproj project
5. In the debug tab, connect to the debugger
6. In the debug tab, load code, reset, and go

Console Output
--------------

Interaction with NSH is via the serial console at 57600 8N1 baud.

STATUS
------

1. Note that you must apply the ZNEO patch if you are using ZDS-II 5.0.1.
See the README.txt file in the parent directory for more information.
This configuration does run correctly with the path applied.

2. I bet that this code, like ostest, will not run if started by a hardware
reset. It may only run when started via the debugger.