1234567891011121314151617181920212223242526272829303132333435363738394041424344454647484950515253545556575859606162636465666768697071727374757677787980818283848586878889909192939495 |
- #
- # For a description of the syntax of this configuration file,
- # see misc/tools/kconfig-language.txt.
- #
- config NET_DM90x0
- bool "Davicom dm9000/dm9010 support"
- default n
- ---help---
- References: Davicom data sheets (DM9000-DS-F03-041906.pdf,
- DM9010-DS-F01-103006.pdf) and looking at lots of other DM90x0
- drivers.
- config NET_CS89x0
- bool "CS89x0 support"
- default n
- depends on EXPERIMENTAL
- ---help---
- Under construction -- do not use
-
- config ENC28J60
- bool "Microchip ENC28J60 support"
- default n
- select SPI
- ---help---
- References:
- ENC28J60 Data Sheet, Stand-Alone Ethernet Controller with SPI Interface,
- DS39662C, 2008 Microchip Technology Inc.
- if ENC28J60
- config ENC28J60_NINTERFACES
- int "Number of physical ENC28J60"
- default 1
- range 1,1
- ---help---
- Specifies the number of physical ENC28J60
- devices that will be supported.
- config ENC28J60_SPIMODE
- int "SPI mode"
- default 0
- ---help---
- Controls the SPI mode. The ENC28J60 spec says that it supports SPI
- mode 0,0 only: "The implementation used on this device supports SPI
- mode 0,0 only. In addition, the SPI port requires that SCK be at Idle
- in a low state; selectable clock polarity is not supported."
- However, sometimes you need to tinker with these things.
- config ENC28J60_FREQUENCY
- int "SPI frequency"
- default 20000000
- ---help---
- Define to use a different bus frequency
- config ENC28J60_STATS
- bool "Network statistics support"
- default n
- ---help---
- Collect network statistics
- config ENC28J60_HALFDUPPLEX
- bool "Enable half dupplex"
- default n
- ---help---
- Default is full duplex
- config ENC28J60_DUMPPACKET
- bool "Dump Packets"
- default n
- ---help---
- If selected, the ENC28J60 driver will dump the contents of each
- packet to the console.
- config ENC28J60_REGDEBUG
- bool "Register-Level Debug"
- default n
- depends on DEBUG && DEBUG_NET
- ---help---
- Enable very low-level register access debug. Depends on DEBUG and DEBUG_NET.
- endif
- config NET_E1000
- bool "E1000 support"
- default n
- config NET_SLIP
- bool "SLIP (serial line) support"
- default n
- ---help---
- Reference: RFC 1055
- config NET_VNET
- bool "VNET support"
- default n
|