123456789101112131415161718192021222324252627282930313233343536373839 |
- README.txt
- ^^^^^^^^^^
- OSTEST Project
- --------------
- ostest.zfpproj is a simple ZDS II - ZNEO 5.0.1 project that will allow you
- to use the ZDS-II debugger. Before using, copy the following files from
- the toplevel directory:
- nuttx.hex, nuttx.map, nuttx.lod
- to this directory as:
- ostest.hex, ostest.map, ostest.lod
- Loading and Executing Code
- --------------------------
- 1. Copy the files to this directory as described above
- 2. Connect the ZiLOG XTools USB debugger.
- 3. Install the USB driver from the ZDS-II device_drivers directory
- 4. Start ZDS-II and load the ostest.zfpproj project
- 5. In the debug tab, connect to the debugger
- 6. In the debug tab, load code, reset, and go
- Hmmm... it appears that the code does not run if started by a hardware reset.
- It runs only when started via the debugger. What is up with that?
- Console Output
- --------------
- OS test results will be provided on the serial console at 57600 8N1 baud.
- STATUS
- ------
- This exemple works fine when started from ZDS-II. But I have seen problems
- when starting from a hardware reset.
|