123456789101112131415161718192021222324252627282930313233343536373839404142434445464748 |
- README.txt
- ==========
- Contents
- --------
- o NSH Project
- o Loading and Executing Code
- o Console Output
- o STATUS
- NSH Project
- -----------
- nsh.zfpproj is a simple ZDS II - ZNEO 5.0.1 project that will allow you
- to use the ZDS-II debugger. Before using, copy the following files from
- the toplevel directory:
- nuttx.hex, nuttx.map, nuttx.lod
- to this directory as:
- nsh.hex, nsh.map, nsh.lod
- Loading and Executing Code
- --------------------------
- 1. Copy the files to this directory as described above
- 2. Connect the ZiLOG XTools USB debugger.
- 3. Install the USB driver from the ZDS-II device_drivers directory
- 4. Start ZDS-II and load the nsh.zfpproj project
- 5. In the debug tab, connect to the debugger
- 6. In the debug tab, load code, reset, and go
- Console Output
- --------------
- Interaction with NSH is via the serial console at 57600 8N1 baud.
- STATUS
- ------
- 1. Note that you must apply the ZNEO patch if you are using ZDS-II 5.0.1.
- See the README.txt file in the parent directory for more information.
- This configuration does run correctly with the path applied.
- 2. I bet that this code, like ostest, will not run if started by a hardware
- reset. It may only run when started via the debugger.
|